X84; Connecting The Hoses - Panasonic NA-148XR1 Operating & Installation Instructions Manual

Connecting the Hoses
Connect the hoses properly to prevent water leaks .
„ Maximum connection distance of hoses and mains lead
Right side connections
Left side connections
Water supply hose
p
Rise of drain hose
(max . 100 cm)
Drain hose
q
Drain hole
40
145 cm
Water supply hose
95 cm
Sink
Rise of drain hose
(max . 100 cm)
Drain hose
85 cm
Drain hole
95 cm
140 cm
Sink
40 cm
Water supply hose
„ Mains water pressure and water flow
zWater pressure: 0 .03-1 .0 MPa „
If the water pressure exceeds this
value, fit a pressure reducing valve.
„
zWater flow from tap: 5 L/min. or
more
„ Connecting the water supply hose
p
„
zDo NOT twist, squash, modify or
cut the hose .
„
zTighten the nut firmly.
1 Attach one end of the hose to the
water inlet on the appliance and
tighten by hand .
q
2 Attach the other end of the hose to
the tap and tighten by hand .
min .
10 mm
3/4"
Hose with water
supply valve
3 Turn on the tap slowly and make
sure there are no leaks .
„ Draining to a sink or wash basin
Secure the drain hose with an elbow
so that it does not come off by water
pressure during drainage .
CAUTION
Elbow
(supplied)
„ Draining to a stand pipe
(Rear of appliance)
Water inlet
Water supply
hose
„ Draining to a drain hole
Standard hose
NOTE
zDo not twist, pull out or bend the „
drain hose .
zDo not put the hose tip under water . „
Drain hose
CAUTION
Stand pipe
41 41