Emergency - Panasonic NA-148XR1 Operating & Installation Instructions Manual

Opening the Door in an Emergency
When the door stays locked due to
a power failure, or while displaying
an error that starts with "H", the door
can be opened using the following
instructions .
1 Turn off the power, and open the
drain filter cover. (P. 31)
2 When there is water in the drum,
drain the water by removing the
drain filter. (P. 31)
3 Pull down the emergency door
unlock tab .
The door lock is released, and you
can open the door .

Emergency

door unlock tab
32
CAUTION
zThere is a risk of burns during „
operation at high temperatures .
- Operate after temperature has
fallen .
zThere is a risk of injury if you put „
your hand in the drum during
rotation .
- Operate after the rotation has
stopped .
zOpening the door when water „
can be seen through the glass of
the door may cause the water to
spill .
- Drain the water by removing the
drain filter. (P. 31)
Troubleshooting
Problem
- Settings cannot be changed while an operation is in
progress . Only the spin speed, "Extra Rinse" and "Easy
Buttons do not
Iron" settings can be changed when the wash process
work
is paused .
- The Child Lock (
- The door is locked while an operation is in progress .
(P . 14)
- The Child Lock (
- The temperature inside the drum may be very high .
- The water level may be too high .
■ To open the door immediately
Door does not
(1) Switch the appliance off and then on again .
open
(P . 10)
(2) Select the "Cotton" programme .
(3) Select
- If you switch off the appliance or there is a power cut
while the door is locked, it remains locked until the
power is turned on again .
- Rubber parts may give off a smell when you first use
Unusual odour
the appliance, but the smell will go away over time .
- Run a wash at 60 °C to clean the drum . (P . 30)
- The tap may be turned off .
No water going
- The water supply may be disrupted .
into the appliance
- The water supply hose may be frozen . (P . 29)
- The water supply filter may be blocked. (P. 29)
Water builds up - This is normal . Water is automatically supplied if the
during a wash
water level falls .
- If there is excess foam, water is drained out and fresh
water supplied to remove the foam . This is the foam
Water drains out
detection function .
during a wash
- Even if water is directly supplied to the drum, it may
drain away without building up .
- The water supply is automatically stopped if the water
Water supply
volume in the drum reaches a certain level, and some
stops and water is
water may drain away . This feature is called the
drained away
overflow detection function.
Cause and Measures
) may be activated . (P . 28)
) may be activated . (P . 28)
in "Mode" (P . 26), and start operation .
33 33