Do you have a question about the xl830l and is the answer not in the manual?
Questions and answers
Shaun Edmeads
April 27, 2025
How to set the xl830l to test parasitic draw on my car battery
1 comments:
Mr. Anderson
May 14, 2025
To test parasitic draw on a car battery using the Excel XL830L multimeter:
1. Set the multimeter to the 10A (amps) DC range. 2. Move the red probe to the 10A input port on the multimeter. 3. Turn off the car and remove the key from the ignition. 4. Disconnect one battery terminal (usually the negative). 5. Connect one multimeter probe to the disconnected battery cable. 6. Connect the other probe to the battery terminal. 7. Read the current draw on the display. Do not exceed 10 amps. 8. If you're getting a current draw, remove fuses one by one to find the circuit causing the drain.
If the reading is positive, the probes may be reversed, but that does not affect finding a parasitic draw.
This answer is automatically generated
Виктор
April 17, 2025
То работает то не работает в чем причина,
1 comments:
Mr. Anderson
May 9, 2025
The Excel XL830L could be working intermittently due to a poor connection or bad crimp at the connector, especially if moving the wire bundle or applying pressure improves the issue. Make sure all plugs are fully seated and check for shorts.
This answer is automatically generated
Nimal he nry obeyesekere
April 16, 2025
How do i fix the battery
1 comments:
Mr. Anderson
May 8, 2025
To fix the battery for the Excel XL830L:
1. Disconnect the test leads from all measurement circuits. 2. Remove the two screws on the bottom of the case. 3. Open the case and remove the old battery. 4. Insert a new 9V battery (NEDA 1604, 6F22, or 006P type), making sure to match the battery polarity correctly. 5. Close the case and tighten the screws completely before use.
Need help?
Do you have a question about the xl830l and is the answer not in the manual?
Questions and answers
How to set the xl830l to test parasitic draw on my car battery
To test parasitic draw on a car battery using the Excel XL830L multimeter:
1. Set the multimeter to the 10A (amps) DC range.
2. Move the red probe to the 10A input port on the multimeter.
3. Turn off the car and remove the key from the ignition.
4. Disconnect one battery terminal (usually the negative).
5. Connect one multimeter probe to the disconnected battery cable.
6. Connect the other probe to the battery terminal.
7. Read the current draw on the display. Do not exceed 10 amps.
8. If you're getting a current draw, remove fuses one by one to find the circuit causing the drain.
If the reading is positive, the probes may be reversed, but that does not affect finding a parasitic draw.
This answer is automatically generated
То работает то не работает в чем причина,
The Excel XL830L could be working intermittently due to a poor connection or bad crimp at the connector, especially if moving the wire bundle or applying pressure improves the issue. Make sure all plugs are fully seated and check for shorts.
This answer is automatically generated
How do i fix the battery
To fix the battery for the Excel XL830L:
1. Disconnect the test leads from all measurement circuits.
2. Remove the two screws on the bottom of the case.
3. Open the case and remove the old battery.
4. Insert a new 9V battery (NEDA 1604, 6F22, or 006P type), making sure to match the battery polarity correctly.
5. Close the case and tighten the screws completely before use.
This answer is automatically generated
инструкция на русском есть.,