Management Options; Access Control List; Change Password - NETGEAR WG602 User Manual

Access Control List

The optional Access Control window lets you block or allow the network access privilege of the
specified stations through the WG602 Wireless Access Point. This provides an additional layer
of security. Follow these steps:
1. Choose the Access Control option from the AP Setup menu in the WG602 Web Server
home page. Click Allow or Block to enable MAC address filtering. Click Disable to
disable Access Control feature.
2. Enter the MAC address for each station to be managed, in the MAC Address field and
click Add.
3. When you are done, click the Apply button for the changes to take effect.
Configuration Description
Specifies the options of the MAC Access Control List: Disable,
Access Control Allow, or Block.
Default: Disable
Specifies the MAC address for the station to be included in the
MAC Address
Access Control List.
Device Name Specify the name to identify the device.
Displays the current MAC Address Control List entries. The
Access Control List
maximum number of MAC Address entries is 100.
You may Add, Edit, or Delete the Access Control List entries.
13

Management Options

Change Password

1. To change the current password, choose the Password option from the AP Setup menu in
the WG602 Web Server home page. The default password is "password."
2. Change your password. Click Apply for the new password to take effect.
Important Note: Be sure to write down your new password, otherwise you will not be able to
access the Access Point setup. You can restore the default password "password" by clicking on
Yes radio button and then clicking on the Apply button to restore to the default password.
Configuration Description
Current Password Specifies the current password in use.
New Password Specifies the new password to be used.
Repeat New Password Retype the intended new password.
Two radio buttons options: Yes or No
Restore Default Password
Default: No
14