Page 1
Installation and Installation and Installation and Operation Manual Operation Manual Operation Manual 8-inch Wide Screen w/IR Transmitter Color Monitor OT01005710-200212...
Page 2
Installation Guide Installation Guide 1 To install the monitor into the seat head cushion you must ensure 1. Slide monitor onto dash mount S2 and then tighten using that the monitor connecting cable assembly has already pull through via the supporting pipe. fastener.(Optional) 2 Before connecting the monitor, pull the connecting cable assembly through the headrest shroud as shown in diagram 2.
Electrical Connections (General) Basic Operation (Monitor) A (R) A (L) RED-ACC YELLOW-BATTERY BLACK-GND AV B OX Interconnect Cable 13 PIN Assembly , Monitor TO MONITOR SERIAL NO. ADAPTORS INPUT DC-13.2V FUSE 2A MADE IN TAIWAN IN 1 IN 2 A (L) A (R) A (L) A (R)
User Guide - Remote Controller: Press to the desire setting CH/DISC/SET POWER ON / OFF POWER MODE Down Adjustment MENU COLOR Up Adjustment MEMORY Press to the desire setting CH/DISC/SET Mode Selection POWER MODE CH/DISC/SET MENU Menu (Activation of OSD and POWER MODE Function Selection)
Remote Controller : Display Mode : Replacement of battery 1. Press MENU to indicate OSD 1. Use a small coin to ply open 2. Select SCREEN MODE battery holder from compartment. remote controller 2. Remove old battery and put in a 3.
Precautions : 1. This unit should be install by qualified technicians or service personnel. 2. This product is designed to operate with a 12 volt, negative ground battery system. 3. Disconnect the ground wire from the battery terminal before connecting the electrical system.