Whistler WS1080 User Manual page 62

"Init SD Card" appears when the scanner is turned
on
• The MicroSD Card is not properly formatted. Use the
PC Application to reformat the card.
• The MicroSD Card may not be inserted fully. Press
the MicroSD Card into the slot until a click is heard
and the card is fully inserted in the slot.
The scanner does not function
• Ensure that the scanner is equipped with fresh
batteries. If powering the scanner from external
power, make certain that the USB power
plug is fully inserted into the scanners USB jack.
Low battery warning beeps and message on LCD
display
• Recharge rechargeable batteries or replace alkaline
batteries. Ensure that the battery type selection
switch in the battery compartment is set to
the correct battery type.
• Please consider using an external charger whenever
possible to keep batteries maintained.
MicroSD Card error messages
The scanners MicroSD Card must be formatted
correctly for proper operation. If the MicroSD Card is
corrupted, defective, improperly formatted or missing
or if essential files or directories are not present on
the card, the scanner displays an error message. If
you experience an error message while using your
scanner in the field, take a moment to ensure that the
MicroSD card is fully inserted in the slot. If this does not
correct the problem, refer to the following table for the
meanings of the various error codes and steps you can
take to correct the problem:
62