Assembly Instructions - Startone MK-200 User Manual

Assembly instructions

4 Assembly instructions
Voltage supply
10
Unpack and carefully check that there is no transportation damage before using the
unit. Keep the equipment packaging. To fully protect the device against vibration,
dust and moisture during transportation or storage use the original packaging or
your own packaging material suitable for transport or storage, respectively.
Set up the device in the desired location.
The device can be powered by batteries or with the included AC adapter.
Batteries
1. Make sure that the device is turned off before you connect it to the power
supply, or disconnect it, or connect it to other devices. This is to protect the
speakers from damage.
2. Take off the battery compartment cover on the underside of the keyboard.
3.
Insert six AA/R6 size batteries. Pay attention to the correct polarity according to
the marks.
NOTICE!
Possible damage by leaking batteries
Leaking batteries can cause permanent damage to the device.
Take batteries out of the device if it is not going to be used for a
longer period.
Always use batteries of the same type and do not use new and used batteries
at the same time.
4. Reattach the battery compartment cover and snap it into place.
Power adapter
1. Make sure that the device is turned off before you connect it to the power
supply, or disconnect it, or connect it to other devices. This is to protect the
speakers from damage.
2. Connect the cable from the power adapter outlet to the [12V] socket on the
rear panel of the keyboard.
Plug the power adapter into a properly wired mains wall outlet.
keyboard