Reference Manual for the Model CG814M Wireless Cable Modem Gateway
You can use some of the LEDs to verify connections.
the front panel of the CG814M Gateway. These LEDs are green when lit.
Table 1-1.
LED Descriptions
Label
Activity
Power
On
Off
Test
On
Off
Cable Link
On (Green)
Off
Cable
On
Traffic
Off
Wireless
On
Blink
Local
On (Green)
(Local Area
Blink (Green)
Network)
On (Yellow)
Blink (Yellow)
Off
USB
On (Green)
Blink (Green)
Off
1-6
Table 1-1
Description
Power is supplied to the gateway.
Power is not supplied to the gateway.
A system failure has occurred. Reboot the gateway.
Normal operation.
Configuration of the cable interface by your cable service provider
is complete.
Configuration of the cable interface is still in progress.
Data is being transmitted or received on the cable interface.
The cable interface is idle.
Indicates that the wireless Access Point is operating normally.
Data is being transmitted or received on the wireless interface.
The Local port has detected link with a 100 Mbps device.
Data is being transmitted or received at 100 Mbps.
The Local port has detected link with a 10 Mbps device.
Data is being transmitted or received at 10 Mbps.
No link is detected on this port.
The Local port has detected link with a USB device.
Data is being tranmitted or received through USB.
No link is detected on the USB port.
lists and describes each LED on
Introduction