When I Enter A Url Or Ip Address I Get A Timeout Error; Using The Reset Button To Restore Factory Default Settings - NETGEAR WG602v3 Reference Manual

Reference Manual for the NETGEAR 54 Mbps Wireless Access Point WG602v3
• The computer with the wireless adapter may not have the correct TCP/IP settings to
communicate with the network. Restart the computer and check that TCP/IP is set up properly
for that network. The usual setting for Windows Network Properties is "Obtain an IP address
automatically."
• The access point's default values may not work with your network. Check the access point
default configuration against the configuration of other devices in your network.
• For full instructions on changing the access point's default values, see the Reference Manual
on the Resource CD for the NETGEAR 54 Mbps Wireless Access Point WG602v3.

When I enter a URL or IP address I get a timeout error.

A number of things could be causing this. Try the following troubleshooting steps:
• Check whether other PCs work. If they do, ensure that your PCs TCP/IP settings are correct. If
using a Fixed (Static) IP Address, check the Subnet Mask, Default Gateway, DNS, and IP
Addresses.
• If the PCs are configured correctly, but still not working, ensure that the WG602v3 is
connected and turned on. Connect to it and check its settings. If you cannot connect to it, check
the LAN and power connections.
• If the WG602v3 is configured correctly, check your Internet connection (DSL/Cable modem
etc.) to make sure that it is working correctly.

Using the Reset Button to Restore Factory Default Settings

The Reset button (see
functions:
• Reboot. When pressed and released quickly, the WG602v3 will reboot (restart).
• Reset to Factory Defaults. This button can also be used to clear ALL data and restore ALL
settings to the factory default values.
To clear all data and restore the factory default values:
Use something with a small point, such as a pen, to press the Reset button in for at least 10
1.
seconds.
Release the Reset button.
2.
The factory default configuration has now been restored, and the WG602v3 is ready for use.
Troubleshooting
"WG602v3 Wireless Access Point Rear Panel" on page
202-10060-02, February 2005
2-6) has two
6-3