NETGEAR WG602v3 Reference Manual page 23

Reference Manual for the NETGEAR 54 Mbps Wireless Access Point WG602v3
Turn on your computer, connect the power adapter to the WG602v3 and verify the
d.
following:
The power light goes on.
The LAN light of the wireless access point is lit when connected to a powered on PC.
2 C LAN
ONFIGURE
The WG602 Wireless Access Point can be configured remotely from Microsoft Internet
Explorer browser version 5.0 or above, or Netscape Navigator web browser version 4.78 or
above on your computer.
The WG602v3 is set by default to be a DHCP client. So, if the WG602v3 has not yet been
a.
installed, and there is no DHCP server on the network, you can log in to the WG602v3
using its default IP address. 192.168.0.227 is the default IP address of your access point.
Note: This procedure which uses a static IP configuration. If WG602v3 has already been
installed or it is connected to a network where there as a DHCP server as commonly found
in home routers, you can the NetBIOS login described in
Using Its Default NetBIOS Name" on page
Open a Web browser such as Internet Explorer or Netscape Navigator.
b.
Connect to the WG602v3 by entering its default address of
c.
browser.
A login window like the one shown below opens:
d.
Figure 3-3: Login window
Basic Installation and Configuration
W A
AND IRELESS
202-10060-02, February 2005
CCESS
"How to Log In to the WG602v3
3-9.
http://192.168.0.227 into your
3-5