Wg111 Default Wireless Configuration Settings - NETGEAR WG111 User Manual

WG111 Default Wireless Configuration Settings

If this is a new wireless network installation, use the factory default settings to set up the network
and verify wireless connectivity. If this is an addition to an existing wireless network, you will
need to identify the wireless configuration and security parameters already defined.
Your NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111 factory default basic settings are:
• Network Name Service Set Identification (SSID): Any (First available network)
Note: In order for the WG111 Wireless USB 2.0 Adapter to communicate with a wireless
access point or wireless adapter, all devices must be configured with the same wireless
network name (SSID).
• Network Mode (Infrastructure or Ad-hoc): Infrastructure
• Data security WEP encryption: Disabled
The section below provides instructions for setting up the NETGEAR 54 Mbps Wireless USB 2.0
Adapter WG111 for basic wireless connectivity to an access point. The procedures below provide
step-by-step installation instructions for Windows PCs. Use the procedure that corresponds to the
version of Windows you are using.
Basic Setup
User Manual for the NETGEAR 54 Mbps Wireless USB 2.0 Adapter WG111
202-10026-01
3-3