NETGEAR WG111T User Manual page 32

NETGEAR 108 Mpbs Wireless USB 2.0 Adapter WG111T User Manual
2. Enter the network settings.
a. Select Computer-to-Computer (Ad Hoc) for the Network Type.
b. Select or enter the Network Name (SSID) for the Ad Hoc network.
c. In the Profile box, type the name of the profile.
d. Click Apply.
3. Save your settings in a Profile.
a. Click the Save Profile button.
All the configuration settings are saved in this profile.
b. Click Apply.
c. Click Close to exit the Smart Wizard, or Cancel to return to the previous settings.
4. Configure the PC network settings.
a. Configure each PC with either a static IP address or with the IPX protocol.
Note: For instructions on configuring static IP addresses, refer to the networking
tutorial on your NETGEAR CD.
b. Restart the PCs.
5. Verify wireless connectivity between your peer devices.
Use the Ping program:
a. On the Windows taskbar click the Start button, and then click Run.
Figure 2-6
2-8
v2.0, February 2007