Hose And Cable Lengths; Levelling The Washing Machine; Water Supply Hose - Sandstrom S814WMB13 Instruction Manual

INSTALLATION

Hose and Cable Lengths

How to connect from the left side

Levelling the Washing Machine

There are 4 levelling feet on the underside. They must be adjusted to make sure the washing machine
is level.
1. On each stand, loosen the lock nut by turning it clockwise with a spanner.
2. Adjust all four feet by rotating upwards or downwards.
3. Use a spirit level to ensure the washing machine is level.
4. Tighten each lock nut by turning them anti-clockwise (towards the
washing machine body), again using a spanner.
Ensure all four lock nuts are tightened securely. Check the feet are still bolted to
the washing machine - if they're unbolted, the washing machine will move around.

Water Supply Hose

Points to remember
• Follow the instructions in this section to avoid water leaks.
• Don't connect the hose to a combination tap.
• Don't twist, squash, modify or cut the hose.
• Optimum water pressure in the water mains pipe is 0.03 MPa - 0.8 MPa. If the water pressure is set
higher than this, you will need to install a depressurising valve. Water-flow from the tap should be
more than 5 litres per minute. If you're unsure, ask a qualified technician to connect the hose.
• This unit must only be connected to cold water mains using the new water inlet hose provided.
• If your washing machine is delivered in freezing weather conditions, leave it at room temperature
for 24 hours after you've set it up before using it. This ensures there's no ice blocking the water
supply hose. If your water supply hose freezes, add 2 or 3 litres of warm water to the drum. Then
run a "Drain" only programme.
~80cm
~90cm 8
kg
~85cm
How to connect from the right side
~130cm
Delicate ~40cm
20
~135cm
Lock nut
9