Table of Contents
Advertisement
Quick Links
220-240V 50 Hz WASHER INSTALLATION INSTRUCTIONS
W1004.5638A
Table of Contents
WASHER SAFETY ..............................................................2
WASHER DISPOSAL ..........................................................2
INSTALLATION REQUIREMENTS .....................................3
Tools and Parts ..................................................................... 3
Location Requirements ....................................................... 3
Drain System ........................................................................ 4.
Electrical Requirements ...................................................... 5
INSTALLATION INSTRUCTIONS .......................................5
Before you start: remove shipping materials .................... 5
Connect Drain Hose ............................................................. 6
Connect Inlet Hoses ............................................................. 7
Level Washer ........................................................................ 8
Complete Installation Checklist .......................................... 9
INSTALLATION NOTES
Date of purchase: _________________________________________
Date of installation: _______________________________________
Installer: _________________________________________________
Model number: ___________________________________________
Serial number: ____________________________________________
Models
6AWTW5700X
6AWTW5550X
Advertisement
Table of Contents
Related Manuals for Whirlpool 6AWTW5700X
Summary of Contents for Whirlpool 6AWTW5700X
-
Page 1: Table Of Contents
Connect Drain Hose ............. 6 Connect Inlet Hoses ............. 7 Level Washer ................ 8 Complete Installation Checklist .......... 9 INSTALLATION NOTES Date of purchase: _________________________________________ Date of installation: _______________________________________ Installer: _________________________________________________ Model number: ___________________________________________ Serial number: ____________________________________________ Models 6AWTW5700X W1004.5638A 6AWTW5550X... -
Page 2: Washer Safety
WASHER SAFETY WASHER DISPOSAL... -
Page 3: Installation Requirements
INSTALLATION REQUIREMENTS Your installation may require additional parts. For information on ordering, contact your dealer. Tools and Parts 8212656RP 3.0 m (10 ft.) Inlet hose, Black EPDM (2 pack) Gather required tools and parts before starting installation. 8212641RP 1.5 m (5 ft.) Inlet hose, Black EPDM (2 pack) 8212646RP 1.2 m (4 ft.) Inlet hose, Black EPDM (2 pack) Tools needed:... -
Page 4: Drain System
DRAIN SYSTEM You will need: A water heater set to 60° C (140° F). Drain system can be installed using a floor drain, wall standpipe, An earthed electrical outlet located within 1.2 m (4 ft) of power floor standpipe, or laundry tub. Select method you need. cord on back of washer. -
Page 5: Electrical Requirements
INSTALLATION INSTRUCTIONS ELECTRICAL REQUIREMENTS Before you start: remove shipping materials It is necessary to remove all shipping materials for proper operation and to avoid excessive noise from washer. Move washer A 230 volt, 50 Hz., AC only, 10-amp, fused electrical supply is required. -
Page 6: Connect Drain Hose
Remove packing tray from tub Place drain hose in standpipe Drain hose form 114 mm (4.5") Remove tape from washer lid, open lid and remove cardboard Place hose into standpipe (shown in picture) or over side of packing tray from tub. Be sure to remove all parts from tray. laundry tub. -
Page 7: Connect Inlet Hoses
CONNECT INLET HOSES Insert washers into hoses The new inlet hoses supplied with this washer must be used. Do not re-use old inlet hoses. NOTE: Both hoses must be attached and have water flowing to inlet valves. If you are only connecting to a cold water tap, you must use a Y-adapter (not provided). -
Page 8: Level Washer
14.. Secure drain hose Adjust leveling feet Laundry Tub Standpipe Wall 113 mm 4.5" 113 mm 113 mm 4.5" (4.5") (4.5") (4.5") Jam nut Secure drain hose to laundry tub leg, drain standpipe, or inlet If washer is not level, use a 14 mm or 9/16" open-end or hoses for wall standpipe with beaded tie strap. -
Page 9: Complete Installation Checklist
COMPLETE INSTALLATION CHECKLIST Check electrical requirements. Be sure you have correct electrical supply and recommended earthing method. Check that all parts are now installed. If there is an extra part, go back through steps to see what was skipped. Check that you have all of your tools. Check that yellow shipping materials were completely removed from back of washer. - Page 10 NOTES...
- Page 11 NOTES...
- Page 12 W1004.5638A © 2011 04/11 All rights reserved. Printed in U.S.A.