HP ProBook 640 G2 Maintenance And Service Manual page 93

11. Optical drive (see Optical drive on page
12. Keyboard (see Keyboard on page
13. Hinge covers (see Hinge cover on page
14. Base enclosure (see
15. System board (see
16. Fan/heat sink assembly (see
17. Top cover (see Top cover and TouchPad on page
Remove the display assembly components:
1. Position the computer upright, with the front toward you.
2. Open the computer as far as possible.
3. If it is necessary to replace the display bezel:
a. Close the computer, position it so you can access the bottom of the display, and then open the
computer slightly.
b. Flex the inside edges of the top edge (1), the left and right sides (2), and the bottom edge (3) of
the display bezel until the bezel disengages from the display enclosure. The display bezel is
available using spare part number 840658-001.
4. If it is necessary to replace the display panel:
a. Remove the four M2x3L P1 screws that secure the display panel to the display enclosure.
● 781959-001—35.6-cm (14.0-in), LED, AntiGlare display panel, UWVA
● 784476-001—35.6-cm (14.0-in), LED, AntiGlare display panel, SVA HD+
46).
48).
55).
Base enclosure on page
System board on page 59).
Fan and heat sink assembly on page
57).
61).
65).
Display assembly 83