Advertisement
1
CONNECTING
Connect the satellite speakers to the output splints on the back panel of the Sub-woofer. Please note to match
the color, the cord with red sign to the red output.
2
Connect the subwoofer to the Audio device.
Using Audio connecting cable , connect the Line-input port of the subwoofer to Line-out of the Audio Device
(Such as the computer, Discman, etc).
3 Playing the audio device
Plug the power cord into the AC outlet and turn on the power switch, Now your speaker system is ready for using
and the power indicator is on .When press the
adjust the volume and bass; The 3D indicator is on when you press the 3D key and the system is in
at the same time, if you press the key again and the 3D indicator is off, the system is in the stereo mode; Adjusting
the volume control and the Super bass, then you can enjoy the music.
SPECIFICATIONS:
Power output:
RMS 8W 2+14W(THD=10%)
Signal to noise ratio: 85dBA
Input port: Stereo RCA Line-in
Input impedance: 10Kohm
Adjust mode: Front key , remote
Bass unit: Magnetically shielded,5 inch paper cone,4ohm
Mid-range unit: Magnetically shielded,3 inch paper cone,4ohm
Tweeter unit : Magnetically shielded,
Input power: Refer to the rear panel
Subwoofer dimensions:
155(W) 235(H) 329(D)mm
Satellite dimensions
110(W) 180(H) 70(D)mm
Weight: About 5.7kg
TROUBLESHOOTING
No sound from any speakers:
Is there power to the system?
Ensure that your subwoofer is plugged securely into a working AC wall outlet and power indicator is on.
Ensure that the power switch on the subwoofer is on.
Are you receiving an Audio Signal?
Connect your speakers to an alternate audio source, such as portable CD player or walkman to determine
that your speakers are working.
Popping/Buzzing/Humming from the System:
Are your cable connections secure?
Ensure the input cable is snugly inserted into the input socket on the rear of the subwoofer.
Try plugging the system into a different AC wall outlet.
Note: A slight low level of hum or vibration is normal as the subwoofer contains a transformer.
Distorted, Little, or No Sound in One or all Satellite Speakers:
Are your Soundcard Settings Properly Configured?
Ensure your computer has the latest soundcard drivers from the manufacturer.
Most computers contain a standard two-channel soundcard and will not require any adjustments to the
speaker configuration.
Adjust your computer`s internal volume settings for left-right balance.
Ensure that there are nicks, cuts, kinks in your input cable.
Jiggle the cables at the subwoofer input sockets whilst playing music through the system to detect a break in
the audio signal.
Adjust the master volume control whilst playing music through the system to determine whether the level of
distortion changes.
Determine if the problem persists in the same channel or moves to the opposite channel when the left and right
speaker connections and reversed.
No sound or weak bass from the subwoofer:
Is the bass volume too low?
Adjust your computer`s internal treble and bass volume settings to mid-level.
VOL+/-
W+/- on the subwoofer (or remote),you can
3/4 inch ,8
ohm
3D mode,
Advertisement
