Installing The Heat Sink Assembly; Removing The Memory - Dell Vostro 3250 Owner's Manual

Figure 10.

Installing the heat sink assembly

1. Place the heat sink assembly in the slot by aligning with the screw holders.
2. Tighten the screws to secure the heat sink assembly to the system board.
3. Connect the heat sink assembly cable to the system board.
4. Install:
a. heat sink fan cover
b. optical drive
c. hard drive assembly
d. front bezel
e. cover
5. Follow the procedures in

Removing the memory

1. Follow the procedures in
2. Remove the cover.
3. Pry the securing clips away from the memory module until it pops up. Remove the memory module
from its socket on the system board.
14
After Working Inside Your
Before Working Inside Your
Computer.
Computer.