HP 501 Quick Start Manual page 4

HP 501 802.11ac Wireless Client Bridge Quickstart
Mounting on a wall or ceiling
1.
Hold the mounting bracket against the wall or ceiling where it will be
installed. Mark two holes for the screws (wall anchors).
2. Drill two holes for the wall anchors, typically 4.7 mm (3/16 inch) in
diameter, and then insert the anchors and tap them flush with the wall or
ceiling surface.
3. Use the mounting screws to attach the spring clips and mounting
bracket to the wall or ceiling.
4. Attach the three antennas.
5.
Align the tab slots on the back of the HP 501 with the retention tabs on
the mounting bracket.
6. Slide the HP 501 onto the mounting bracket until it is fully engaged. Do
not let go of the HP 501 until you confirm that it is firmly in place.
2
1
3
Wall or ceiling mounting
1: Screws and wall anchors
2: Spring clips
3: Mounting bracket
4: HP 501
4
4
Placing on a desktop
The HP 501 can also be installed on a desktop using the mounting bracket. Slide
the HP 501 base onto the mounting bracket, and then place it on the desktop in
the preferred location.
1
Desktop mounting
1: HP 501 base tab slots
2: Mounting bracket
Installation
2