Integy i8MT-2016W Manual page 7

While if you have our optional radio control system- 2.4G at hand, please read as following:
LEARNING THE OPTIONAL TRANSMITTER - 2.4G
You may use the following diagram to confirm the location and function of each of these features.
A. ON/OFF Switch: Controls power to the transmitter.
B. Steering Wheel: Steering the vehicle left and right.
C. Throttle Trigger: Contols the speed and the Forward/Reverse
direction of the vehicle.
D. Throttle Trim: Ajusts the neutral position of the throttle so
your vehicle responds correctly to the trigger.
E. Steering Trim: Adjusts the neutral position of the throttle so
your vehicle travels straight.
F. Throttle Reverse Switch: Reverses the forward/reverse direction
of the steering wheel.
G. Steering Reverse Switch: Reverse the left/right direction of
steering wheel.
H. Antenna: Transmits radio signals to your receiver.
I. Recharging Jack: you can charge the battery with your charger
if you are using rechargeable batteries in your transmitter.
Caution: You can not recharge Non-rechargeable batteries.
J. Battery Power Indicators: Signal when it is time to replace your
transmitter batteries when the red indicator lit.
K. Steering Knob: Adjusts the steering angle
L. Start button: Channel 3.
2.4GHZ Frequency Pin Setup
1. Switch on the transmitter.
2. Turn on the receiver power(you can choose any channel), plug the jumper into"BIND/BATT" stop of
receiver. When the indicator starts flashing, that means the receiver comes into the set code mode.
At this point, pull out the jumper immediately.
3. The receiver can automatically find the nearest transmitter to match with. Once they match successfully,
the indicator would keep lighting(at this moment, please plug the jumper into" BIND/BATT" again.)
And if the indicator flashes continuously, that means they haven't matched successfully, please re-try.
-5-