Connections And Controls; Using The Controls And Connections - Toshiba 26/32WL36 Owner's Manual

A wide variety of external equipment can be connected via the sockets located on the front of the TV.
Whilst all the necessary adjustments and controls for the TV are made using the remote control, the buttons on
the TV may be used for some functions.
RED – Power On
GREEN – On-timer set
Power Button
Switching on
If the power-on light is unlit press the POWER button
underneath the bottom left corner of the TV to switch the
set on, then press a number button on the remote
control to see the screen, it may take a few moments.
To put the set into Standby press
control. To view the TV press
number buttons. The picture may take a few seconds to
appear. Standby should only be used for short periods
of time.
To set up the TV you will now need to use the on-screen
menus. Press the MENU button on the remote control to
see the menus.
The menu bar at the top of the screens will show five
different topics shown in symbols. As each symbol is
selected by pressing the S or R button on the remote
control, its respective options will appear below.
To use the options press the Q button on the remote
control to move down through them and OK, S or R to
select the required choice. Follow the on screen
instructions. The functions of each menu are described in
detail throughout the manual.

Connections and controls

Press the centre of
the flap to open it
i on the remote
i
again or any of the
Press the centre of
the flap to open it

Using the controls and connections

To alter the volume press —
To alter the programme position press
Press MENU and S , R , Q or P to control the sound
and picture options.
Press MENU to finish.
When connecting mono sound equipment to EXT 6,
connect the audio output of the equipment to the
L/Mono socket on the TV.
To select the Input, press
EXT6 as described on page 40. The TV will automatically
sense the type of signal.
Please always refer to the owner's manual of the
equipment to be connected for full details.
Please note: Inserting the headphone jack will mute the
sound from all speakers.
8
INPUT 6
(EXT 6)
+
j
.
e e f f
F .
B
until the display shows