Connecting To A Wireless Network; Network Type - Digihome 50278FHDDLEDCNTD Operating Instructions Manual

Connecting to a Wireless Network

• To make your modem' s SSID visible, you should
change your SSID settings via modem's software.
The TV cannot connect to the networks with hidden
SSID.
For connecting to a wireless LAN network, you
should perform the following steps:
1. Connect broadband ISP connection ethernet
cable to the ETHERNET INPUT of your modem.
2. Ensure that Nero Media Home software is
installed to your PC (for DLNA function).
3. To configure wireless settings please refer
Network Settings section in the following sections.
• A Wireless-N router (IEEE 802.11a/b/g/n) with
simultaneous 2.4 and 5 GHz bands designed to
increase bandwidth. Optimized for smoother and
faster HD video streaming, file transfers, and wireless
gaming.
• Use LAN connection for quicker file sharing between
other devices like computers.
• The frequency and channel differ depending on the
area.
• The transmission speed differs depending on the
distance and number of obstructions between the
transmission products, the configuration of these
products, the radio wave conditions, the line traffic, and
the products that you use. The transmission may also
be cut off or get disconnected depending on the radio
wave conditions DECT phones, or any other WiFi 11b
appliances. The standard values of the transmission
speed are the theoretical maximum values for the
wireless standards. They are not the actual speeds of
data transmission.
• The location where the transmission is most effective
differs depending on the usage environment.
• To configure wireless settings please refer wifi section
in Settings menu.
• Wireless feature of the TV supports 802.11 a,b,g &
n type modems. It is highly recommended that you
should use IEEE 802.11n communication protocol in
order to avoid any possible problems while watching
videos.
• You must change your modem's SSID when there are
any other modems around with the same SSID. You
can encounter connection problems otherwise. Use
wired connection instead if you experience problems
with wireless connection.
Configuring Wired Device Settings
If you are connecting the TV via ETHERNET INPUT,
select Network Type as Wired Device to configure.

Network Type

Network type can be selected as Wired or Wireless
device, in accordance with the active connection to the
TV set. Select this as Wired if you have connected to the
TV a LAN cable.
Configuration Status
This section displays the status of the connection. Select
Connected if you want to activate connection. Select as
Not Connected to end an active connection.
IP Address
If an active connection is available, the IP address will
be displayed on this section. If you want to configure IP
address preferences, press GREEN button and switch
to the advanced mode.
Configuring Wired Network Settings in
Advanced Mode
After pressing GREEN button, Advanced mode will be
available. While in Advanced Mode, press RED button
to edit settings. When finished, press OK to save, Press
RETURN/BACK to cancel.
Configuring Wireless Device Settings (Optional)
Wi-Fi feature can be used for a wireless network
connection. The feature is used for infrastructure
purposes only, such as connecting to the web, hbb sites
and connecting with DLNA servers (optional).
English - 17 -