Table of Contents
Advertisement
Available languages
Available languages
ENGLISH
1.
Switch trigger
2.
Side grip
3.
Socket
SPECIFICATIONS
Capacities
No load speed (min
Impacts per minute
Max. fastening torque
Overall length
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
.... Read instruction manual.
.............. DOUBLE INSULATION
Intended use
The tool is intended for fastening bolts and nuts.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety
Warnings
WARNING! Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Explanation of general view
4.
Anvil
5.
O-ring
6.
Pin
Model
Standard bolt
High tensile bolt
Square drive
-1
)
Net weight
Safety class
M12 - M20
M12 - M16
12.7 mm
294 N·m
270 mm
Save all warnings and
END201-5
instructions for future reference.
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
Work area safety
1. Keep work area clean and well lit. Cluttered or dark
areas invite accidents.
2. Do not operate power tools in explosive
ENE036-1
atmospheres, such as in the presence of
flammable liquids, gases or dust. Power tools
create sparks which may ignite the dust or fumes.
3. Keep children and bystanders away while
ENF002-2
operating a power tool. Distractions can cause you
to lose control.
Electrical safety
4. Power tool plugs must match the outlet. Never
modify the plug in any way. Do not use any
adapter plugs with earthed (grounded) power
tools. Unmodified plugs and matching outlets will
GEA005-3
reduce risk of electric shock.
5. Avoid body contact with earthed or grounded
surfaces such as pipes, radiators, ranges and
refrigerators. There is an increased risk of electric
shock if your body is earthed or grounded.
6. Do not expose power tools to rain or wet
conditions. Water entering a power tool will increase
the risk of electric shock.
7.
Limit mark
8.
Screwdriver
9.
Brush holder cap
6905B
1,700
2,000
2.8 kg
/II
6906
M16 - M22
M16 - M20
19 mm
1,700
1,600
588 N·m
327 mm
5.6 kg
/II
3
Advertisement
Table of Contents
