LogLogic LX 510 Quick Start Manual page 12

Setting Up the Appliance using the Console
12
Note: Use a serial console instead of an SSH connection. Network configuration changes can
disconnect an SSH connection during this procedure. In all circumstances, a serial connection
is maintained.
3. In the terminal program, log in as user root with password logapp.
a. If this is the first time you are setting up the Appliance, change the default password
to another password:
> passwd root
b. Follow the prompts, and be sure to make a note of the change. Do this for both the
CLI and shell logins.
Once logged in, you are automatically set to read/write mode. There is no read-only
console login.
4. Configure the network settings:
a. Set the Appliance IP address and interface network settings:
# set ip IP-address subnet-mask default-gateway interface-name
If you are bonding two interfaces together, use interface-name to indicate bond0
or bond1.
Example:
set ip 10.9.3.250 255.255.255.0 10.9.3.1 eth0
b. Set the DNS server IP address:
# set dns DNS-IP-address
Example:
set dns 10.1.1.5
5. Set the local time zone.
set timezone <Enter>
From the displayed menu, select the time zone where this Appliance is located.
6. Verify your settings:
> show changes
7. Save your changes:
> save
This updates the necessary files so that the network setting changes are permanent.
IMPORTANT! New settings do not go into effect until the Appliance is restarted.
8. View the new network settings to verify they are correct:
> show
9. Restart the network interface:
> network restart
Quick Start Guide