Table of Contents
Advertisement
U
M
SER
ANUAL
C
K
V4.0
OMFORT
IT
3 T
ELEPHONE
This allows you to control the system via phone calls.
There are two sections: one for calls made ("the user calls home") and other for calls received
("the home calls the user").
3.1
C
:
ALLS MADE
To access the home's control from any other telephone, from anywhere, call the home's land
line and let it ring 6 times (default setting), after which it asks for the corresponding pin. (See
"KCTr compatibility with voicemail").
Whether you access one way or another, once you enter the password, the user can use the voice-
mails which are programmed by default (which does not necessarily coincide with the real
programming of the equipment, which is personalised according to the installation's characteristics
and therefore the messages can change):
"If you want to operate the heater, press 1": by pressing 1 a new voice message indicates:
•
"To activate the heater press 1": upon pressing 1 the heater is activated (relay 3 from node
0 is activated, which corresponds to the heater; see KA node 0 by default).
•
"To deactivate the heater press 2": upon pressing 2 the heater is deactivated (relay 3 from
node 0 is deactivated, which corresponds to the heater; see KA node 0 by default).
"If you want to operate the alarms, press 2": if you press 2 a new voice message indicates:
•
"To activate the intrusion alarm, press 1": Upon pressing 1 the intrusion alarm is activated.
(The following script is sent via the BUS: Write 0 2 7).
•
"To deactivate the intrusion alarm, press 2": Upon pressing 2 the intrusion alarm is
deactivated. (The following script is sent via the BUS: Write 0 2 15).
•
"To activate the gas or fire alarm, press 3": Upon pressing 3 the gas or fire alarm is
activated. (The following script is sent via the BUS: Write 37 12 4).
•
"To deactivate the gas or fire alarm, press 4": Upon pressing 4 the gas or fire alarm is
deactivated. (The following script is sent via the BUS: Write 0 2 12).
•
"To activate the flood alarm, press 5": Upon pressing 5 the flood alarm is activated. (The
following script is sent via the BUS: Write 37 12 15).
•
"To deactivate the flood alarm, press 6": Upon pressing 6 the flood alarm is deactivated.
(The following script is sent via the BUS: Write 0 2 13).
"If you want to operate the lights, press 3": If you press 3 a new voice message indicates (as
programmed):
•
"To activate the lighting press 1": Upon pressing 1 the lighting alarm is activated.
•
"To deactivate the lighting press 2": Upon pressing 2 lighting is deactivated.
NOTE: Messages, along with the zone of action can vary relative to the programming. For example,
we can have a voice-message indicating the specific lighting zone to activate or deactivate, etc.
Here we discuss the default programming.
M
ANAGEMENT
Security and Climate
32
of 43
Advertisement
Table of Contents
