Bond HYFP50095-35 Owner's Manual

Red ember livingston 35in. square gas fire table
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

RED EMBER LIVINGSTON 35IN. SQUARE GAS FIRE TABLE
Item# 66872
Model# HYFP50095-35
WARNING
Improper installation, adjustment, alteration, service or maintenance can cause injury or
property damage. Read the owner's manual thoroughly before installing or servicing this
equipment. If the information in this manual is not followed exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
Save these instructions for future use. If you are
assembling this unit for someone else, give this
manual to him or her and read and save for the
future.
Owner's Manual
DANGER
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. If odor continues, keep away from
the appliance and immediately call
your gas supplier or fire department.
WARNING
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
An LP-cylinder not connected for use
shall not be stored in the vicinity of
this or any other appliance.
WARNING
For outdoor use only.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HYFP50095-35 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Bond HYFP50095-35

  • Page 1 RED EMBER LIVINGSTON 35IN. SQUARE GAS FIRE TABLE Item# 66872 DANGER Model# HYFP50095-35 If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish any open flame. 3. If odor continues, keep away from the appliance and immediately call your gas supplier or fire department.
  • Page 2: Safety Information

    • Keep any flammable items away and do not use any other fireplace cover for this unit. • Keep a safe distance to avoid burning skin or clothing. • Do not sit or rest hands or feet on this heating unit. Bond Manufacturing Company | Page 2...
  • Page 3 • Never place hands or fingers on upper portion of this unit while in use. • Keep all electrical cords and fuel supply hose away from heated surfaces. • Combustible material should not be within 72 inches of the top of the unit, or within 48 inches around the entire unit.
  • Page 4 Bond Manufacturing Co. Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate the appliance. For assistance with repair or replacement of the burner or any other parts, calls Bond Manufacturing at 1.866.771.2663.
  • Page 5: Item Description

    CONTENTS Item Description Table Top Control Knob (preassembled) Electronic Igniter (preassembled) Front panel Left panel Right panel M6x12 screw M4x8 screw Hose bracket AAA Battery PVC Cover Tank seat Lava Rocks 1 box Burner (preassembled) Guard (preassembled) 1-866-771-2663 | Page 5...
  • Page 6 Attach 2pcs left panels (F), front panel (E) and right panel (G) to the legs using 16pcs screws . M6x10 Secure the hose to the bottom of the enclosure using the hose bracket ( ) and 2pcs M4x8 screws. Bond Manufacturing Company | Page 6...
  • Page 7 Put the 20 lb. propane gas tank (not included) into the tank holder (M). Turn the wing screw on the outside of the tank holder (M) clockwise to tighten the tank into the tank holder. DANGER Propane tank must be a minimum of 60 inches away at all times.
  • Page 8: Operation

    2. Close the cylinder valve on the propane gas tank if you don’t intend to use it for a long time. WARNING Fire product and propane gas cylinder minimum distance must be over 60 inches (as per right side photo) 60" Bond Manufacturing Company | Page 8...
  • Page 9: Maintenance

    MAINTENANCE • Before performing any maintenance always disconnect propane gas tank. • Keep the heating item free and clear from combustible materials. • Visually inspect burner for obstructions and keep tank enclosure free and clear from debris. • Use a soft brush to get rid of the mild stains, loose dirt and soil after the burner and pumice stones/ lava rocks/LavaGlass™...
  • Page 10: Troubleshooting

    Electrode wire is loose or disconnected Reconnect wire to the igniter box located inside the table behind the igniter box Electrode wire is shorting between valve Contact Bond Manufacturing for a re- and igniter pin placement part No gas flow Check that the gas tank isn’t empty...
  • Page 11: Warranty

    • Use and installation other than what is listed in this manual. Please contact the manufacturer for replacement parts. CONTACT If you have any questions or concerns, please contact Bond Manufacturing Company at the below resources: Toll Free Phone 1-866-771-BOND (2663) | Monday - Friday, 8am - 4:30pm PST Email customer.service@bondmfg.com...
  • Page 12 Bond Manufacturing Company | Page 12...
  • Page 13 TABLE FOYER CARRÉ AU GAZ RED EMBER LIVINGSTON DE 35 PO No de produit 66872 DANGER No de modèle HYFP50095-35 Si vous détectez une odeur de gaz : 1. Coupez l’alimentation en gaz de l’appareil. 2. Éteignez toute flamme nue.
  • Page 14: Renseignements Sur La Sécurité

    • L’unité peut être chaude pendant l’utilisation; n’essayez pas de la déplacer quand elle fonctionne. • Ne laissez jamais cette unité de chauffage sans surveillance pendant l’usage. • Cette unité n’est pas conçue pour la cuisson des aliments. Bond Manufacturing Company | Page 14...
  • Page 15 • Gardez tout article inflammable à l’écart et n’utilisez aucune autre housse de foyer pour cette unité. • Tenez-vous à une distance sécuritaire pour éviter la brûlure de la peau ou des vêtements. • N’asseyez-vous ni reposez les mains ou les pieds sur cet appareil de chauffage. •...
  • Page 16 Pour obtenir de l’aide avec la réparation ou le remplacement du brûleur ou de toute autre pièce, appelez Bond Manufacturing au 1.866.771.2663. REMARQUE : Il vous faut suivre toutes les étapes pour assembler correctement cet appareil de chauffage.
  • Page 17: Article Description

    CONTENU Article Description Qté Plateau de table Bouton de commande (préassemblé) Allumeur électronique (préassemblé) Patte Panneau avant Panneau gauche Panneau droit Vis M6x12 Vis M4x8 Support de tuyan Pile AAA Housse protectrice Support-bouteille Pierres de lave 1 boîte Brûleur (préassemblé) Dispositif de protection (préassemblé) 1-866-771-2663 | Page 17...
  • Page 18: Instructions D'assemblage

    Attachez les 2 panneaux gauches (F), le panneau avant (E) et le panneau droit (G) aux pattes utilisant 16 vis M6x10. Fixez le tuyau au fond de l’enceinte utilisant le support de tuyau (J) et 2 vis M4x8. Bond Manufacturing Company | Page 18...
  • Page 19 5. Posez la bouteille de gaz de 9 kg (20 lb) (non comprise) dans le support-bouteille (M). Tournez la vis à oreilles à l’extérieur du support-bouteille (M) dans le sens horaire pour bien fxer la bouteille dans le support-bouteille. DANGER Réservoir de propane doit être un minimum de 152,4 cm (60 pouces) de distance à...
  • Page 20 2. Fermez le robinet de la bouteille de gaz propane si vous n’avez pas l’intention de l’utiliser pendant une période prolongée. AVERTISSEMENT Produit de l’incendie et la bouteille de gaz distance minimale de propane doivent être de plus de 60 pouces ( selon photo de droite de 60 po côté) Bond Manufacturing Company | Page 20...
  • Page 21: Entretien

    ENTRETIEN • Avant d’effectuer des travaux d’entretien, détachez toujours la bouteille de gaz propane. • Gardez l’appareil de chauffage dégagé de matériaux combustibles. • Inspectez visuellement le brûleur pour des obstructions, et gardez l’enceinte de la bouteille dégagée de débris. •...
  • Page 22: Guide De Dépannage

    Aucun écoulement de gaz Vérifiez si la bouteille de gaz est vide facilement La soupape de sécurité contre Voir « Une chute soudaine du débit de l’écoulement excessif a été activée gaz » ci-dessus Bond Manufacturing Company | Page 22...
  • Page 23: Garantie

    POUR NOUS REJOINDRE Pour toute question ou préoccupation, veuillez communiquer avec Bond Manufacturing aux ressources ci-dessous : Téléphone sans frais 1 866 771-BOND(2663) du lundi au vendredi, de 8 h à 16 h 30 HNP Courriel customer.service@bondmfg.com En ligne www.bondmfg.com...
  • Page 24 Bond Manufacturing Company | Page 24...
  • Page 25: Manual Del Usuario

    No. de artículo 66872 PELIGRO No. de modelo HYFP50095-35 Si percibe olor a gas: 1. Cierre el suministro de gas hacia el electrodoméstico. 2. Apague cualquier llama expuesta. 3. Si el olor persiste, manténgase alejado del electrodoméstico y llame de inmediato a su proveedor de gas o al departamento de bomberos.
  • Page 26: Información De Seguridad

    • El aparato puede estar caliente al usarlo; no intente moverlo mientras esté en uso. • Nunca deje este aparato de calefacción sin vigilancia durante el uso. • Este aparato no está diseñado para cocinar. Bond Manufacturing Company | Page 26...
  • Page 27 • Mantenga los artículos inflamables lejos y no utilice otra funda de chimenea para este aparato. • Manténgase a una distancia segura para evitar la quema de la piel o de la ropa. • No se siente ni descanse las manos o los pies en este aparato de calefacción. •...
  • Page 28 Utilice únicamente el regulador y el ensamblaje de manguera provistos con este aparato. Las piezas de repuesto deben ser proporcionadas directamente por Bond Manufacturing Co. Revise el quemador antes del uso de este aparato. Si el quemador presenta daños de cualquier tipo, no utilice el aparato.
  • Page 29 CONTENIDO Artículo Descripción Cant. Tapa de mesa Botón de control (premontado) Encendedor eléctrico (premontado) Pata Panel delantero Panel izquierdo Panel derecho Tornillos M6x12 Tornillos M4x8 Soporte de manguera Pila AAA Funda protectora Soporte de tanque 1 caja Rocas lavas Quemador (premontado) Dispositivo de seguridad (premontado) 1-866-771-2663 | Page 29...
  • Page 30: Instrucciones De Montaje

    Sujete los 2 paneles izquierdos (F), el panel delantero (E) y el panel derecho (G) a las patas utilizando 16 tornillos M6x10. Fije la manguera al fondo del recinto utilizando el soporte de manguera (J) y 2 tornillos M4x8. Bond Manufacturing Company | Page 30...
  • Page 31 Coloque el tanque de gas de 9 kg (20 lb) (no incluido) en el soporte de tanque (M). Gire el tornillo de mariposa al exterior del soporte de tanque (M) en sentido horario para bien fjar el tanque en el soporte de tanque. PELIGRO El tanque de propano debe tener un mínimo de 152.4 cm (60 pulgadas) de distancia en todo...
  • Page 32: Para Encender

    2. Cierre la válvula del tanque de gas propano si no tiene intención de usarlo durante un período prolongado de tiempo. ADVERTENCIA La distancia mínima del cilindro de gas propano y bol de fuego debe ser superior a 60” (según foto de la derecha). 60" Bond Manufacturing Company | Page 32...
  • Page 33: Mantenimiento

    MANTENIMIENTO • Antes de hacer cualquier mantenimiento, desconecte siempre el tanque de gas propano. • Mantenga el aparato de calefacción despejado y libre de materiales combustibles. • Visualmente revise el quemador para obstrucciones, y mantenga el encerramiento del tanque despejado y libre de residuos. •...
  • Page 34: Resolución De Problemas

    Ningún flujo de gas Compruebe si el tanque de gas esté La llama se apaga vacío facilmente El dispositivo de seguridad de exceso de Ver ‘Caída repentina del flujo de gas’ flujo se ha activado arriba Bond Manufacturing Company | Page 34...
  • Page 35 • Uso y instalación con fines ajenos a los indicados en las instrucciones de este manual. Póngase en contacto con el fabricante para obtener piezas de repuesto. PONERSE EN CONTACTO Si tiene alguna pregunta o preocupación, póngase en contacto con Bond Manufacturing a los recursos abajo: Teléfono sin cargos 1 866 771-BOND(2663) de lunes a viernes, de 8.00 a 16.30 PST...

Table of Contents