Sanyo DC-T44 Service Manual page 13

..
(
CD MECHANISM REMOVAL
4. CD MECHANISM ASSEMBLY & APPLY GREASE (3) INSTALL THE BASE-UP/DOWN SLIDE AND TIMING GEAR
-.
.
.."
(1) APPLY GREASE AND INSTALL T E TRAY SLIDE
Y
1) Apply the grease FLOIL (G-474 B)iat part of right figure.
2) When insert a tray slide (1 5), set up the installation position
with base and tray timing gear as follow figure.
(2) INSTALL THE TRAY GEAR
1) Near the Tray slide (15) in the direction of the arrow.(~)
2) Match the inner gear center of Tray gear (6).
3) Install the Tray move gear (3) with match the outer gear
make(o) of Tray gear (6) as figure below.
GEAR
1) When near the Base up / down slide (14) in the direction o
the arrow(o). set up the four gear(23) as follow figure
position.
2) Insert the timing gear and stop by the screw (2 1).(@)
3) Turn the timing gear (23) to left direction.
A
7
,.(7L
1}. [
A-W-=
I
v
SCREW (21)
.-
0
2
4) Hook the gear tension spring (22) to timing gear(23)
R-m
/7-%1/'
E-K
'a w..
o
J>
"=g'-g'- ~
<)) @
TIMING GEAR (23)
'f/ GEAR TENSION SPRING
o
x
-- -.
I
--
--
II
TRAY MOVE GEAR
–16-