Table of Contents
Advertisement
4. O
PERATION
Control Panel
Description
Menu Map
ÉPIX Drive 900 User Manual Rev. 2
Button
<MENU/ESC>
<UP>
<DOWN>
<ENTER>
Main Level
Protocol
Auto Address
Display Inverse
Start Universe
(Art-Net™ or sACN only)
IP Address #1 to
IP Address #6
(Art-Net™ or sACN only)
Device ID
View Linked Fixture
LED Output
Factory Reset
* - In Art-Net™ mode, the beginnings of the IP addresses can be set to 2 or 10, and
in sACN mode they can also be set to 239.
** - The display will show ÉPIX Strip tour, ÉPIX Bar Tour, or nothing.
Function
Exits from the current menu or function or cycles through the main level
of the menu
Navigates upward through the menu list or increases the numeric value
when in a function
Navigates downward through the menu list or decreases the numeric
value when in a function
Enables the currently displayed menu or sets the currently selected
value in to the current function
Programming Levels Description
Art-Net
Kling-Net
sACN
Yes
No
Yes
No
0–250
(Art-Net™)
1-250
(sACN)
x*.xxx.xxx.xxx
xxxxxxxxxx
1. X** – 18. X**
Off
Red
Green
Blue
White
Fade
Scroll
Yes
No
Selects the Ethernet protocol and determines
what other Menu options are available
Automatically find and address the products
Turn display 180 degrees
Sets the lowest of the 6 consecutive Art-Net™
or sACN universes the product is assigned to
Sets the IP addresses for the ÉPIX Drive 900
Note: The addresses cannot be the same
Shows device ID
Shows the connected products in order
Turn off all LED output
Red LEDs at full
Green LEDs at full
Blue LEDs at full
White LEDs at full
Color roll fade at full
Rainbow roll at full
Resets products to factory defaults
Operation
Firmware V1.1
-9-
Advertisement
Table of Contents
