ZyXEL Communications ZyAir B-1000 Quick Installation Manual page 21

Locate a high position on the wall that is free of obstructions.
1.
Connect two screws (not included) in the wall 60mm apart. You can use the diagram at the end of
2.
this guide to help you mark the screw holes correctly. Use screws with 6mm ~ 8mm (0.24" ~
0.31") wide heads. Do not screw the screws all the way in to the wall. Leave a small gap between
the head of the screw and the wall. The gap must be big enough for the screw heads to slide into
the screw slots and the connection cables to run down the back of the ZyAIR.
Make sure the screws are securely fixed to the wall and strong enough to hold
Adjust the cables.
3.
a. Run the connection cables down the back of the ZyAIR as shown in the following figure.
OR:
b. Run the connection cables upward and along the edge of the ceiling.
ZyAIR B-1000 v.
2
the weight of the ZyAIR with the connection cables.
Figure 6 Run the Cables Down the Back of the ZyAIR
Secure Wireless LAN Access Point
21