Rear Panel - D-Link des-1316 Manual

16-port 10/100mbps ethernet web smart switch with 8 x 802.3af poe ports

Hide thumbs Also See for des-1316:

Table of Contents

Ethernet Ports (Port 9~16):

These ports support network speeds of either 10Mbps or 100Mbps,

and can operate in half- and full- duplex transfer modes. These ports

also supports automatic MDI/MDIX crossover detection function

gives true "plug and play" capability, just need to plug-in the network

cable to the hub directly and don't care if the end node is NIC

(Network Interface Card) or switch and hub

Note: When the port was set to "Forced Mode", the Auto

MDI/MDIX will be disabled.

Rear Panel

AC Power Connector

Reset Button

Figure 4. Rear panel of the Switch

AC Power Connector:

This is a three-pronged connector that supports the power cord. Plug

in the female connector of the provided power cord into this connector,

and the male into a power outlet. Supported input voltages range from

100-240V AC at 50-60Hz.

Reset:

The Reset button is to reset all the setting back to the factory default.

Note: Be sure that you recorded the setting of your device, else all

the setting will be erased when pressing the "Reset" button.

Table of Contents