Mcacc - Pioneer VSX-831 Basic Manual

> Specifications > Settings
Setup the speakers automatically or make desired changes to the equalizer. You can also
check the values set currently for each speaker setting.
Operation:
Use the on-screen displays (OSD) that appear on the TV to make the settings.
Press on the remote controller to display the Home screen, then select MCACC with the
cursors on the remote controller and press ENTER.
Select the item with the cursor / / /
ENTER to confirm your selection.
Use the cursors / to change the default values.
• To return to the previous screen, press
• To exit the settings, press .
> Listening Modes > Playback Function

MCACC

buttons of the remote controller and press
.
Full Auto MCACC
Place the supplied speaker setup microphone in the listening position, measure the test
tones emitted by the speakers, then the unit automatically sets the optimum volume level
for each speaker, the crossover frequencies, and the distance from the listening position.
This also automatically adjusts the equalizers for the speakers and enables correction of
distortion caused by the acoustic environment of the room.
• Calibration takes several minutes to be completed. The speakers emit the test tone at
high volume during measurement, so be careful of your surroundings. Keep the room
as quiet as possible during measurement. If the measurement is interrupted, turn off the
household appliances.
1. Place the supplied speaker setup microphone in the listening position, and connect to
the MCACC SETUP MIC jack on the main unit.
MCACC
SETUP MIC
When putting the speaker setup microphone on a tripod, refer to the illustration when
putting it in place.
2. Select the connected speaker configuration.
The image on the screen changes as you choose the number of channels in "Speaker
Channels", so refer to it when performing the settings. Also use this screen to select
> Basic Manual
Troubleshooting | Appendix
17 17