Cd5Si; Cd5Si Introduction And Installation; Cd5Si Connections; Cd5Si In Use - NAIM CD555 Reference Manual

CD5si

13. CD5si Introduction and Installation

The CD5si should be installed on a dedicated equipment stand intended for the purpose. Do not stand the player directly on
top of another item of Naim Audio equipment. Care should be taken to ensure that the player is level.
A transit screw on the underside of the CD5si case should be removed before use and must be replaced if the unit is to be re-
packed and shipped. This transit screw must not be used in any other Naim product. Do not invert the player once the transit
screw is removed.
CD player control and operation is described in Sections 16, 17 and 18.

14. CD5si Connections

14.1 Rear Panel
Note: Icon descriptions can be found in Section 19.

15. CD5si In Use

15.1 Disc Loading
To load a compact disc pull open the CD drawer using the
handle on the left hand side of the player. Place the disc
on the platter followed by the magnetic puck. Do not use
a puck from any other Naim CD player. Different Naim CD
players use dissimilar pucks.
15.2 Player Maintenance
It is important for reliable operation of the CD5si to ensure
that the surfaces of the transport platter and the underside
of the puck are free of dust or debris which can prevent the
disc from sitting properly and cause it to slip.
To clean the transport platter, take a piece of Blu-Tack and
lightly apply it to the top surface of the magnetic metal hub,
picking up any material attached to it. Brush the plastic
outer edge lightly with your finger or a soft brush to ensure
that it is dust and particle free. Similarly, clean the puck with
Blu-Tack, to remove debris from its underside.
Do not, under any circumstances, use any solvents or fluids
for the cleaning process.
Note: RCA phono and DIN output
sockets should not be connected
simultaneously.
E10
DIN output
ch1
nc
ch2 nc
-ve