Roger Nucleus 5 Fittings Manual

Sound processors

Fitting Guide

Roger and Cochlear sound processors Nucleus 5

and Nucleus 6

This guide provides detailed information on how Roger receivers should be used with Cochlear sound processors

Nucleus 5 (CP810) and Nucleus 6 (CP910) to achieve the best possible performance.

A 2013 study by Dr. Jace Wolfe of Hearts for Hearing Foundation, Oklahoma City, revealed that the use of Roger systems in

combination with cochlear implants resulted in significant improvements in speech recognition at high noise levels (70 to 80

dB (A)) over fixed gain FM and Dynamic FM technologies (see www.phonakpro.com)

Set-up

The table below shows what is required to connect the sound processor to a Roger receiver.

Cochlear

Nucleus 6 (CP910) / Nucleus 5 (CP810)

Roger 14

Jace Wolfe (2013), Evaluation of speech recognition of cochlear implant recipients using a personal digital adaptive radio frequency system.

Accepted by the

Journal of the American Academy of Audiology.

Build Standard C or higher

Sound processor

Adapter / Roger receiver

Cochlear

Nucleus 6 (CP910) / Nucleus 5 (CP810)

Cochlear Euro Accessory Adapter and Roger X

Table of Contents

Do you have a question about the Nucleus 5 and is the answer not in the manual?

Page 1 Nucleus 5 (CP810) and Nucleus 6 (CP910) to achieve the best possible performance. A 2013 study by Dr. Jace Wolfe of Hearts for Hearing Foundation, Oklahoma City, revealed that the use of Roger systems in combination with cochlear implants resulted in significant improvements in speech recognition at high noise levels (70 to 80 dB (A)) over fixed gain FM and Dynamic FM technologies (see www.phonakpro.com)
Page 2: Getting Started
A Roger inspiro is required for programming Roger X. Connect Roger X to the sound processor. Turn Roger inspiro on, hold it close to Roger X (less than 10 cm/4 inches) and select the function Check. Click Manage, scroll to ‘CI module’ then click OK.
Page 3: Troubleshooting
Roger 14 attached to the “Phonak Roger 14 / ML Roger X plugged directly Roger 14 plugged directly into 14i Checker” and plugged into the MLx Audio into the MLx Audio Checker Cochlear Monitor Earphones Checker Fitting Guide | Roger and Cochlear sound processors Nucleus 5 and Nucleus 6...
Page 4 Check. Roger receiver information will appear on the inspiro’s screen. NOTE: Deactivation of the audio input is possible by using the Cochlear remote control. Available for Roger 14 (02) and Roger X (02) only. Fitting Guide | Roger and Cochlear sound processors Nucleus 5 and Nucleus 6...

Nucleus 6