NEC LT150Z User Manual page 26

Adjust the Tilt Foot
1) Lift the front edge of the projector.
2) Press the Tilt button on the top of the projector to extend the
adjustable tilt foot (maximum height).
1
3) Press and hold the Tilt button.
4) Lower the front of the projector to the desired height and re-
lease the button to lock the Adjustable tilt foot.
There is approximately 5 degrees of up and down adjustment
for the front of the projector. The rear foot height can be
changed, but the vertical distance from the bottom to the desk
or floor should be 0.14 " (3.5mm) to make the projector hori-
zontal on the flat surface. To fine-adjust the height of the rear
foot, remove the spacer (black rubber) and rotate the rear foot
to the desired height.
* If the projected image does not appear square to the screen
then use keystone correction for proper adjustment.
4
up
Do not use the tilt-foot for purposes other than originally intended.
Misuses such as gripping the tilt-foot or hanging on the wall can
cause damage to the projector.
2
1
3
4
down
Adjusting the Image Using Auto Adjust
The Auto Adjust function automatically optimizes the image in RGB
mode.
[Poor picture]
[Normal picture]
OFF ON
POWER
VIDEO S-VIDEO RGB1 RGB2
AUTO ADJ. LASER
SELECT
Press the Auto Adjust button to adjust Position-H/V and Pixel Clock/
Phase for an optimal picture. Some signals may not be displayed
correctly or take time to switch between sources.
E–26