Operation; Connecting The Power Cable, Turn On The Projector - NEC LT150Z User Manual

3.OPERATION

Connecting the Power Cable and Turn on the Projector
Before you turn on your projector, ensure that the computer or video
source is turned on and that your lens cap is removed.
1
Connect the supplied power cable to the projector.
O
ID E
S - V
B L
R O
R G
N T
C O
P C
D IO
A U
Plug the supplied power cable in the wall outlet. The projec-
tor will go into its standby mode and the power indicator will
glow orange.
2
Turn on and off the Projector
OFF ON
POWER
VIDEO S-VIDEO RGB1 RGB2
AUTO ADJ. LASER
SELECT
To turn on the projector:
Only after you press the "ON/STAND BY" button on the pro-
jector cabinet or "POWER ON" button on the remote control
will the power indicator turn to green and the projector be-
come ready to use.
NOTE: To turn the projector on by plugging in the power cable, use
the menu and enable the "Auto Start" feature. (See page E-39.)
NOTE: Immediately after turning on the projector, screen flicker may
occur. This is not a fault. Wait 3 to 5 minutes until the lamp lighting
is stabilized.
To turn off the projector:
First press the Power (ON/STAND BY) button on the projec-
tor cabinet or the POWER OFF button on the remote control
for a minimum of two seconds. The power indicator will glow
orange. After the projector turns off, the cooling fans keep
operating for 90 seconds.
NOTE: Do not disconnect the power cable during this time. Then,
unplug the power cable. The power indicator will go out.
I N
A C
R D
C A
P C
B
U S
E O
V ID
Power button
POWER ON/STAND BY button
Indicator
Status of indicator light: turn on
Normal mode:
stand by
STATUS
POWER
steady orange light
Eco modo:
stand by
STATUS
POWER
steady orange light
Status of indicator light: turn off
ON
POWER
steady green light
3
Adjust a Projected Image
Select the Computer or Video Source
VIDEO S-VIDEO
R G
B
S - V
I D E
O
P
E–24
ON/STAND BY
STATUS STATUS
POWER POWER
flashing green light
steady green light
for one minute.
ON/STAND BY
STATUS STATUS
POWER POWER
steady green light
flashing green light
for one minute. (Eco mode)
(Normal mode)
ON/STAND BY
press a minimum of
two seconds
cooling down stand by
POWER POWER
change to flashing steady orange light
green light
RGB1 RGB2
PC CARD