Projecting An Image (Basic Operation; Turning On The Projector - NEC HT410 User Manual

3. PROJECTING AN IMAGE (BASIC OPERATION)

3. PROJECTING AN IMAGE (BASIC OPERATION)
This section describes how to turn on the projector and to project a picture onto the screen.

Turning on the Projector

NOTE:
• The projector has two power switches: a main power switch and an ON/STAND BY button.
• When plugging in or unplugging the supplied power cable, make sure that the main power switch is pushed to the off (O)
position. Failure to do so may cause damage to the projector.
To turn on the main power to the projector, press the Main Power switch to the on ( I ) position.
The POWER indicator will light orange.
Before you turn on your projector, ensure that the computer or video source is turned on and that your lens cap
is removed.
Only after you press the ON/STAND BY button on the projector cabinet or POWER ON button on the remote
control for a minimum of 2 seconds will the power indicator turn to green and the projector become ready to use.
LAMP
STATUS
POWER
ON/STAND BY
Steady orange light
See page E-49 for more details.
NOTE: The POWER and STATUS (LED) indicators blinking green at the same time indicates the main power was interrupted
during previous operation. Wait for 60 seconds (cooling period) to see if the lamp turns on by itself.
Cabinet controls
SELECT
SOURCE
AUTO
ADJ.
Standby
LAMP
STATUS
POWER
LAMP
STATUS
POWER
IN
DE O
S- VI
on o
L/ m
Pb
C b/
Y
R
L
NT RO
CO
Remote control
OFF POWER
COMPONENT
VIDEO C-VIDEO
S-VIDEO
MENU
Blinking Power On
LAMP
STATUS
POWER
Blinking green Steady green
light
E-21
ON
COMPUTER
COMP.
AUTO ADJ.
AUTO
LAMP
STATUS
POWER
light