Indicator Display List - NEC DLP CINEMA NC2500S User Manual

6. Appendix
Problem
The projector cannot be operated
with the remote control.
The STATUS indicator blinks in red.
An error code is displayed.

6-2. Indicator display list

See the descriptions below when the blinking or lighting of the two indicators on the projector's control panel and the rear
STATUS indicator on the backside of the projector is observed. The projector also has a warning function that uses a buzzer.
MMS
STATUS
6-2-1. POWER indicator
Indicator condition
Off
Blinking light Green
Orange
Steady light Green
Orange
6-2-2. STATUS indicator
Indicator condition
Off
Blinking light (Red)
38
Make sure the remote control transmission unit is facing the light reception unit on the projector.
Check whether the batteries are still good. Replace with new batteries.
Check whether there is any obstructing object between the remote control and the light
reception unit on the projector.
Check whether you are outside of the remote control's effective range (7m).
Check whether the remote control cable has become disconnected, if you are using the remote
control by connecting with the remote control cable.
Your projector may have trouble. Please contact your dealer/distributor for instructions.
See the "Error Code List" (page 40).
MMS STATUS indicator
Projector condition
The main power is off.
The projector is getting ready to turn on.
The douser is closed.
The projector is cooling down.
The projector is turned on.
The projector is in standby.
Projector condition
Normal
Error
Check these items
POWER indicator
STATUS indicator
Wait for a moment.
Wait for a moment.
An error message is displayed in
the LCD screen. Check the content
of the error.
Note
-
-
-
Note
-