Advertisement
1-2. TEMPORARILY
SETTING UP AND CONNECTING
CP-I PWB ASSEMBLY
The following is an example of how to place and connect the main board without a jig, when repairing the CP-1 PWB assembly.
1.
Place the mechanism unit and main board up side down as
2.
Operete the unit using the buttons on TM-1 PWB or the
a whole on a flat surface with foil side of the main board
remote control.
facing up.
M-PF2LN~A-4
CP-I PWB Assembly (Foil side)
.
/~~7Boord
Screws @) ——___
*
,—
v
/'-
TM-1 PWB
\("+
R
Cassette Compartment
~)
7
\
-w
\
Mechanism Main Unit
Fig. 1-1-4
1-3. INSTALLATION
OF THE FRONT PANEL
When installing the front panel to the chassis after repaires and adjustments.
1.
Pressing down the door opener lever of the mechanism
Note: Opened cassette door position does not install the front
main unit.
panel to the chassis.
2.
Set the cassette door to half-opened state as shown in Fig.
L
L
1-1-5, and install the front panel to the chassis.
M-PF2LN/TA-5
(Position A)
Cassette Door
(Position B)
Fig. 1-1-5
–7-
Advertisement
