Advertisement
1. DISASSEMBLY
1-1.
REMOVAL OF CABINET, MECHANISM
UNIT, AND MAIN BOARD
REMOVING
THE CABINET
PARTS
(Fig. l-l-l)
1.
Spread
out the lock clamps
(C) in the arrow direction
1.
2.
Remove the cabinet and bottom cover by removing the four
slightly and remove the TM-1 PWB as shown in Fig. 1-1-2.
screws @ and four screws @.
2.
Remove the screw@
at the chassis.
Remove the front panel by removing the locks of the clamps
3.
Remove the red screw@
in the chassis, remove the red
(A) using a screwdriver, etc. and slightly rotating the bottom
screw @, and remove the holder in this order.
part in the direction of the arrow.
4.
Remove
the two screws ~ and two screws @ of the
mechanism unit. The two screws @of the cassette tray can
Notes:
Electrical
adjustments
for the this model can be
performed with only the cabinet removed.
When replacing the bottom cover, do not tighten the
screws @ too much. Excess tightness may damage
the screws taps on the chassis.
REMOVING
THE MECHANISM
MAIN UNIT AND THE
CP-1 PWB ASSEMBLY
(Fig. 1-1-2 and l-l-3)
After removing the cabinet parts, remove the mechanism
unit
and the CP-1 PWB assembly connected as follows.
be removed easily by pushing the tray lock lever in the
arrow direction to remove the lock as shown in the enlarge
view A and by pushing the lid opener lever in the arrow
direction to remove the lock as shown in the enlarge view
B.
5.
Lift up the whole mechanism
unit and main board (CP-1
PWB assembly), and as shown in Fig. 1-1-3, push the two
lock clamps (D) of the chassis in the arrow direction so that
they can be removed from the chassis.
._
L
M-PF2LN/-rA-l
Front Panel
Unit
ver
Fig. 1-1-1
–5-
Advertisement
