Advertisement
BEFORE YOU BEGIN
Remove contents from box. Remove the foam separators that protect the components from damage during shipping.
Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during
shipping. Because the Bumper Buggie was 95 percent assembled and packed at the factory, there should not be any
problems, even if the box has a few scars or dents.
Estimated Assembly and Set-Up Time
Adult assembly required.
Allow up to 15 minutes for assembly, not including initial charge time.
Allow up to 12 hours for initial charge (see below for charging information).
Charging the Battery
Your Bumper Buggie may not have a fully charged battery; therefore it is a good idea to charge the battery prior to use.
• Initial charge time: 12 hours
• Recharge time: up to 8 hours,
depending on the level of depletion
Charger
Plug
Charger
Port
Required Tools
We recommend the use of mechanic's grade tools.
Phillips Screwdriver
Need Help? Visit our web site for updates and a list of authorized service centers at www.razor.com
or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
• Run time: up to 40 minutes
• Average battery life: 250 charge/discharge cycles
1
Plug the charger port into the
input socket on the back of the
Bumper Buggie. The charger works
with the power switch in either the
on or off position.
Battery should be charged a minimum
of 8 hours after each use. When the
vehicle is not in regular use recharge
the battery at least once a month
until normal use is resumed.
2
Plug the charger plug into a wall
outlet.
2
WARNING:
DO NOT USE NON-RAZOR
PRODUCTS WITH YOUR
RAZOR BUMPER BUGGIE.
The Bumper Buggie has been
built to certain Razor design
specifications. The original
equipment supplied at the time
of sale was selected on the basis
of its compatibility with the other
parts. Certain aftermarket products
may or may not be compatible.
WARNING: Always
disconnect your Bumper Buggie
from the charger before cleaning
with liquid.
WARNING: Always
recharge the battery once a month
when product is not in regular use.
Failure to do so could result in a
battery that will no longer accept
a charge.
Note: If your charger does not
look like the one illustrated,
your unit has been supplied
with an alternative charger.
The specifications and charging
procedure would not change.
Chargers have built-in over-charge
protection to prevent battery from
being over-charged.
Be sure to properly align the
groove on the charger port with
the corresponding socket on
the back of the Bumper Buggie;
otherwise, no charging action
will occur.
Advertisement
