Pump Filter - Haier HW80-BD1626 User Manual

Care and cleaning

Pump filter

Please check the pump filter regurarly and if the appliance
- doesn´t drain the water,
- doesn´t spin,
- cause unusual noise while running.
Warning!
Scalding Risk! Water in the pump filter can be very hot! Before any
action please ensure water has cooled down.
1. Turn off and unplug the machine.
2. Open service flap. You can either use a coin or a
screwdriver.
3. Provide a flat container to catch leach water.
There could be bigger amounts!
4. Pull the drainhose out and hold its end above the
container.
5. Take the sealing plug out of the drainhose.
6. After complete drainage, unscrew and remove counter
clockwise the pump filter.
7. Remove contaminants and dirt.
8. Clean carefully pump filter, e.g. using running water.
9. Refix it thoroughly.
10. Close drainhose and push it back into the machine.
11. Close service flap
Warning!
Pump filter sealing has to be clean and unhurt.
If the lid is not full tightened, water can escape.
18 19
Water inlet valve and inlet valve filter
To prevent blockage of water supply by foreign substances,
clean inlet valve filter regularly.
Period of disuse
If the appliance is left idle for a longer period, pull out
the electrical plug (1) and turn off water supply (2).
Open the door to prevent formation of moisture and
odours. Let door open while not used.
Before next usage check carefully power cord, water inlet
and drain hose. Make sure everything is properly installed
and without leackage.
Care and cleaning
2