Troubleshooting - NEC NDV-28 Owner's Manual

Troubleshooting

Symptom
No power.
The power is on, but
the DVD player does
not work.
No picture.
No sound.
The DVD player does
not start playback.
The remote control
does not work properly.
The picture is not
correct, such as double
picture, red picture or
no colour.
20
Possible Cause
• The power cord is disconnected.
• No disc is inserted.
• The TV is not set to receive DVD
signal output.
• The video cable is not connected
securely.
• The equipment connected with the
audio cable is not set to receive DVD
signal output.
• The power of the equipment
connected with the audio cable is
turned off.
• The AUDIO options are set to the
wrong position.
• An unplayable disc is inserted.
• The rating level is set.
• The remote control is not pointed at
the remote sensor on the DVD player.
• The remote control is too far from the
DVD player.
• The progressive scan is ON at a
normal TV which cannot receive
progressive scan.
• The TV OUTPUT SELECT (SETUP-
DISPLAY) is set at S-Video, while the
DVD is connected to YPbPr.
• The TV OUTPUT SELECT (SETUP-
DISPLAY) is set at YPbPr, while the
DVD is connected to S-Video.
Correction
• Plug the power cord into the wall outlet
securely.
• Insert a disc. (Check the disc indicator
in the display window is lit.)
• Select the appropriate video input
mode on the TV.
• Connect the video cable securely.
• Select the correct input mode of the
audio receiver so you can listen to the
sound from the DVD player.
• Turn on the equipment connected with
the audio cable.
• Set the AUDIO option to the correct
position, then turn on the DVD player
again by pressing POWER.
• Insert a playable disc. (Check the disc
type and regional code.)
• Change the rating level.
• Point the remote control at the remote
sensor of the DVD player.
• Operate the remote control closer to
the DVD player.
• Turn Off the progressive scan.
See Page 11.
• If connection is using Component
(YPbPr), then ensure YPbPr is selected
from (SETUP-DISPLAY-TV OUTPUT
SELECT). See page 11.
• If connection is using S-VIDEO, then
ensure S-VIDEO is selected from
(SETUP-DISPLAY-TV OUTPUT
SELECT). See page 11.