Table of Contents
Advertisement
en
Connecting the
appliance
After installing the appliance, wait at least
½ hour before switching on the appliance.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance to
220-240 V/50 Hz alternating current
via a correctly installed earthed socket.
The socket must be fused with a 10 A to
16 A fuse.
If the appliance is to be operated
in a non European country, check on the
rating plate whether the indicated voltage
and current type correspond to the values
of your mains supply. The rating plate
is situated in the bottom left hand side of
the appliance. The mains connection
cable may be replaced by an electrician
only.
Warning
!
Never connect the appliance to electronic
energy saver plugs or to power inverters
which convert the direct current to 230 V
alternating current (e.g. solar equipment,
power supplies on ships).
24
Switching on
the appliance
Fig. 2
Press main switch 1. The temperature
display light flashes until the required
temperature has been reached. The
appliance starts cooling, the interior light
is switched on when the door is open.
The factory has recommended and set
the following temperatures:
Refrigerator compartment
Perishable food should not be stored
warmer than +4 °C.
+4 °C
Hide quick links:
Advertisement
Table of Contents
