Honeywell CL15AM Maintenance Manual page 8

USE & OPERATION (CONTINUED)
COOLER LOCATION
Make sure to position the air cooler correctly before you set up and start using the product. Please refer
to the COOLER LOCATION section of the separate Safety & Maintenance Guide.
ASSEMBLY INSTRUCTIONS FOR CASTERS
Rear casters do not come pre-installed onto this unit.
Please refer to Fig. 1, 2 and 3 for instructions on how to install the casters onto the air cooler.
Fig. 1
Locate the 2 casters
and remove from
packaging
FILLING WITH WATER
CAUTION:
Unplug the unit from the electrical power outlet before emptying or refilling the
water tank.
Open the Water Fill Door located on the side of the unit.
The Water Level Indicator is located at the front of the unit. Refill the water tank
when water level is low. Do not fill water above the "Max." water level mark.
Check the water level in the tank before running the COOL function. Make sure
that the water in the tank is above the minimum water level mark. Running the
unit in COOL mode with inadequate water may cause pump failure.
WATER INDICATOR LIGHT
The unit is equipped with a low water sensor. In Cooling Mode, when water in the water tank is above
the minimum level mark, the Water Indicator Light will be turned on. When the water level is below the
minimum level, the indicator light will be turned off. The water pump will automatically stop to pause
evaporative cooling.
To activate the Water Indicator Light and continue operating in cooling mode, you must refill the water
tank. Switch OFF the unit and unplug from the power outlet. Fill the water tank with fresh water above
the minimum water level mark. Plug in and switch the unit ON again. Activate cooling mode if not yet
activated.
2
Fig. 2
Push the leg of the caster
into the caster hole on the
unit
Fig. 3
Make sure the caster is
tightly installed and not
easily removed
Water Fill Door