Important Safety Advice - Dimplex CDE2TI Cadiz Eco Owner's Manual

Dimplex Cadiz Eco
Models :
CDE2TI(B), CDE2ECC(B) and CDE24ECC(B)
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
Model Description
CDE2TI(B) Switch, Thermostat & Digital Timer Control
CDE2ECC(B) Electronic Climate Control
CDE24ECC(B) Electronic Climate Control

Important Safety Advice

If the appliance is damaged, check immediately
with the supplier before installation and
operation.
This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience or knowledge if they
have been given supervision or instruction
concerning the use of the appliance in a safe
way and understand the hazards involved.
Children shall not play with the appliance.
Cleaning and user maintenance shall not be
made by children without supervision.
Children of less than 3 years should be kept
away unless continuously supervised. Children
aged from 3 years and less than 8 years shall
only switch on/off the appliance provided that
it has been placed or installed in its intended
normal operating position and they have been
given supervision or instruction concerning
the use of the appliance in a safe way and
understand the hazards involved. Children
aged from 3 years and less than 8 years shall
not plug in, regulate and clean the appliance
or perform user maintenance.
CAUTION: Some parts of this product can
become very hot and cause burns. Particular
attention has to be given where children and
vulnerable people are present.
WARNING: This appliance must not be used
in a bathroom.
WARNING: Do not use in areas where petrol,
paint or flammable liquids are used or stored.
DO NOT put objects through the openings of
the appliance. This could lead to functional
faults, possibly to the ignition of the object.
If the mains lead is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in order
to avoid a hazard.
CAUTION: Avoid use of an extension cord
because the extension cord may overheat and
cause risk of fire.
The heater carries a warning symbol to
alert the user to the risk of fire that exists
if the heater is accidentally covered.
Unplug the heater when not required for long
periods.
WARNING: Do not use this heater in the
immediate surroundings of a bath, a shower
Watts
or a swimming pool.
2000
WARNING: This heater must not be located
2000
immediately below a fixed socket outlet.
2400
WARNING: In order to avoid a hazard due to
inadvertent resetting of the thermal cut-out,
this appliance must not be supplied through an
external switching device, such as a timer, or
connected to a circuit that is regularly switched
on and off by the utility.
Note that due care and consideration must be
taken when using this heater in series with a
thermal control, a program controller, a timer
or any other device that switches on the heat
automatically, since a fire risk exists when the
heater is accidentally covered or displaced
General
The heater is designed for operation on an AC electricity supply, and
is suitable for use in domestic dwellings and similar indoor locations.
Always ensure that the appliance is stood on a firm, level base near to,
but not directly beneath, a suitable fixed socket outlet.
The heater is fitted with wheels, castors and a handle for ease of
movement. Selector switches provide a choice of heat output and an
adjustable thermostat enables the room temperature to be controlled
accordingly. It is supplied with a cord and plug ready for use.
The supply cord should be uncoiled before use (see 'Storage').
DO NOT pull the heater along by the mains lead.
Important: The heater must only be operated with the wheels and castors
fitted and in the upright position as shown in Fig. 1.
Warning: The heater complies with stringent safety standards but to
ensure efficient operation surfaces of the heater will become hot and
contact with these areas should be avoided, particularly between the air
outlet slots on the top and sides.
The control panel area is designed to be at a far lower temperature to
allow the safe operation of the controls at any time. Momentary contact
with any part of the heater should not cause injury. However aged, infirm
persons or young children should not be left unsupervised in the vicinity
of the heater. Please Note: After switching the heater on for the first time
and after an extended period of non-use a smell may be noticed, this
is quite normal, the fumes are non-toxic and will quickly disappear. We
recommend that you open a window to ventilate the room when using
the heater during this time. Used in an environment where background
noise is very low, it may be possible to hear a sound which is related
to the element. This is normal and should not be a cause for concern.
Electrical
WARNING: THIS APPLIANCE MUST BE EARTHED
CAUTION: If you use this heater in conjunction with a thermal control,
programme controller, timer or any other device which switches the heater
on automatically observe all safety warnings at all times.
Positioning the Heater
Select the position for the heater ensuring there is clearance from any
furniture and fittings of at least 300mm above the heater and 150mm
each side. The appliance should only be operated on a flat stable surface.
Operation
Important – Objects or clothing must not be placed on this heater. Before
using the heater ensure that all warnings and instructions have been
read carefully.
To bring the heater into use plug it in. Neon indicating lights located at
the controls area will glow when the appliance is actually heating.
Controls
On/Off button -
elements. When the On/Off button is activated a neon light 'x' illuminates
below the control button.
This button controls the electricity supply to the
.