Makita pj7000 Instruction Manual page 5

1
012255
Then tighten the lock lever up to secure the angle guide.
The scale on the angle guide indicates the distance from
the top of the workpiece to the center of the blade
thickness.
The angle guide is removable from the fence according
to the need of your work. To remove the angle guide,
loosen the lock lever and turn the knob clockwise until it
comes out of the upper end of the fence.
Fence
NOTE:
Remove the angle guide according to the need of
•
your work when using the tool with the angle of the
fence adjusted to other than 0 ﾟ. When you need to
use the angle guide under the above condition, be
sure to adjust the depth of groove to get a proper
depth.
1
5
4
012256
1
2
3
10mm
10mm
4
012257
The angle of the fence can be adjusted between 0° and
90° (positive stops at 0°, 45° and 90°). To adjust the
angle, loosen the lock lever and tilt the fence until the
pointer points to the desired graduation on the angle
scale. Then tighten the lock lever to secure the fence.
When the fence is set at 90°, both the distance from the
center of the blade thickness to the fence and the
distance from the center of the blade thickness to the
1. Knob
2. Down
3. Up
4. Center of blade
2
thickness
3
4
1. Fence
2. Lock lever
3. Angle scale
4. Tighten
5. Loosen
2
3
1. Lock lever
2. Pointer
3. Angle scale
4. Center of blade
thickness
5. Blade cover
5
bottom of the blade cover are 10 mm.
Set plate
2
5: 3
4mm
4
10mm
10mm
6
6mm
012258
1
012259
Use the set plate as shown in the figures when cutting
slots in thin workpieces.
Switch action
012271
CAUTION:
Before plugging in the tool, always check to see
•
that the slide switch actuates properly and returns
to the "OFF" position when the rear of the slide
switch is depressed.
Switch can be locked in "ON" position for ease of
•
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, slide the slide switch toward the "I (ON)"
position. For continuous operation, press the front of the
slide switch to lock it.
To stop the tool, press the rear of the slide switch, then
slide it toward the "O (OFF)" position.
5
1. Lock lever
1
2. Pointer
3. Angle scale
4. Set plate
5. Thickness of set
plate
6. Center of blade
thickness
7
7. Blade cover
1. Set plate
1. Slide switch
1