Operation - Hitachi ML 36DL Handling Instructions Manual

en
BATTERY REMOVAL / INSTALLATION
Battery removal
Push the battery latch to remove
(6).
CAUTION
Never short-circuit the battery.
Battery installation
1. Press on the battery cover on the mower to
open it.(4)
2. Remove the safety key from the mower.(5)
3. Press the pushbuttons together on the bat-
tery. (6a)
4. With a slight pressure push the battery into
the battery compartment up to the stop until
the battery sits firmly on the contact plug of
the mower. (6b)
5. Insert the safety key again.(11a)
6. Press once on the battery cover to close it. (4)

OPERATION

Adjusting the cutting height (7)
CAUTION!
Danger - risk of injury!
Adjust the cutting height only while motor
is switched off and the cutting blade has
stopped!
1. To unlock, press the lever to the side and hold
(7).
For a short lawn slide the lever in the di-
rection of the front wheel. Minimum step
1: 2.8 cm
For a longer lawn slide the lever in the di-
rection of the rear wheel. Maximum step
6: 6.8 cm
2. Release the lever and slide it forward or back-
ward until it engages in the desired step.
Handle bar adjustment (8)
1. Press the two buttons on the handle bars (8 a)
2. Adjust to the desired height (8b)
3. Release the buttons and engage the handle
bar.
Level indicator (9)
The level indicator is pressed upwards by the air
stream during mowing (9a). When the grass cat-
cher is full, the level indicator rests against the cat-
cher (9b). The grass catcher needs to be emptied.
18
Attaching the grass catcher (10)
the battery
1. Lift up the baffle plate (10a) and hang the grass
catcher into the holders. (10b)
Emptying the grass catcher (10)
1. Lift the baffle plate.
2. Unhook the grass catcher and remove it to the
rear.
3. Empty grass catcher.
4. Lift up the baffle plate and hang the grass cat-
cher back into the holders. (10)
Switching on the motor (11)
Start the lawn mower only on level ground, and
not in high grass. The ground must be free from
foreign objects, such as stones. Do not lift or tilt
the lawn mower to start it.
1. Insert the safety key again and turn it (11a).
2. Keep the start button pressed (11b).
3. Pull the safety bar toward the handle bar and
hold it there (11c).
4. Release the start button.
Switching off the motor
1. Release the safety bar. (11c)
2. Wait until the cutter blade stops.
3. Remove the safety key from the mower (5).
Status display of battery (12)
All of battery illuminated: battery 100% - 67%
charged
Half of battery illuminated: battery 66% - 34%
charged
Battery not illuminated
Speed / motor (13)
It is possible to select between normal and eco
modes
Normal mode: 3200 +/- 100 min
Eco mode: 2600 +/- 100 min
Status display of Overheat (14)
If all 3 lamps blinks, high temperature status.
Then it can not be start till cooled it down.
When cooled it down, it can be started again.
CAUTION!
Danger - risk of injury!
Remove or replace the grass catcher
only while the motor is switched off and
the cutting blade has stopped.
ML 36 DL / ML 36 DAL
Operation
-1
-1