Table of Contents
Advertisement
4. Make sure the lid is closed by pushing down until it locks into place.
NOTE: The 360° base allows the kettle to rotate but DO NOT perform this action while the
kettle is ON.
5.
Place the Kettle onto the power
base and plug the cord into a
power socket and switch on.
TIP: Wind excess cable beneath the base.
7. The Kettle will automatically switch OFF once the water is boiled. Lift the Kettle off
the base and pour the water into your desired vessel.
WARNING: The water will be hot. Be sure to pour slowly especially if filled to the
maximum level. Do not overfill the kettle, because boiling water may be ejected.
NOTE: To re-boil you may need to wait a few seconds for the control to reset.
12
6.
Press the ON/OFF switch to the
ON position. The ON/OFF switch
will illuminate.
Advertisement
Table of Contents
