Black & Decker BDV030 User Manual page 4

Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
ENGLISH
The 12 Vdc outlet is strictly for use as an accessory outlet,
the maximum output is 5A. Never insert a vehicle cigarette
lighter into the unit's 12 Vdc accessory outlet.
Make sure the appliance is disconnected from all charging
power sources before beginning the battery boost
procedure.
Never attempt to use the ac charger and dc charging
connection simultaneously.
The appliance will not start a vehicle with a flat battery.
The appliance will not function correctly if you have other
electrical faults on the vehicle.
This appliance is to be used only on vehicles with a DC
negative earth system.
Additional safety instructions for batteries and
chargers
Batteries
Never attempt to open for any reason.
Do not expose the battery to water.
Do not store in locations where the temperature may
exceed 40 °C.
Charge only at ambient temperatures between 10 °C and
40 °C.
Charge only using the chargers provided with the
appliance.
When disposing of batteries, follow the instructions given
in the section "Protecting the environment".
Under extreme conditions, battery leakage may occur.
When you notice liquid on the batteries, carefully wipe the
liquid off using a cloth. Avoid skin contact.
In case of skin or eye contact, follow the instructions below.
Warning! The battery fluid is a diluted sulphuric acid and may
cause personal injury or damage to property. In case of skin
contact, immediately rinse with water. If redness, pain or
irritation occurs seek medical attention. In case of eye contact,
rinse immediately with clean water and seek immediate
medical attention.
Chargers
Your charger has been designed for a specific voltage.
Always check that the mains voltage corresponds to the
voltage on the rating plate.
Warning! Never attempt to replace the charger unit with a
regular mains plug.
Use your Black & Decker charger only to charge the battery
in the tool with which it was supplied. Other batteries could
burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
Have defective cords replaced immediately.
Do not expose the charger to water.
Do not open the charger.
4
Do not probe the charger.
The battery must be placed in a well ventilated area when
charging.
The following symbols are found on your charger:
Your charging base is double insulated; therefore
no earth wire is required.
Fail-safe isolating transformer. The mains supply
is electrically separated from the transformer
output.
The charger automatically shuts off if the
130
o
C
ambient temperature becomes too high. As a
consequence the charger will be inoperable. The
charging base must be disconnected from the
mains supply and taken to an authorised service
centre for repair.
The charging base is intended for indoor use
only.
Electrical safety
This tool is double insulated; therefore no earth
wire is required. Always check that the power
supply corresponds to the voltage on the rating
plate.
If the supply cord is damaged, it must be replaced by the
manufacturer or an authorised Black & Decker Service
Centre in order to avoid a hazard.
Features
This appliance includes some or all of the following features:
1. Storage compartment
2. 12 Vdc accessory outlet
3. On/off button
4. Vehicle boost button
5. Recharge button
6. Area light button
7. 12 Vdc charging socket
8. Area light
9. Mains charging adaptor
10. 12 Vdc vehicle adaptor
USE
Charging the unit (fig. A)
This unit is shipped in a partially charged state. Charge the
unit before first use using the mains charging adaptor (9) for
15 hours or until the green battery status LED (13) lights.
Charge after each use until the green battery status LED
(13) lights.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents