Wash Options - Hotpoint LSF 712 Operating Instructions Manual

Wash options*

The OPTIONS may only be set, modified or reset after
the wash cycle has been selected and before the Start/
Pause button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected was cycle (see Table of wash cycles), the
corresponding LED flashes rapidly 3 times.
If an option is selected which is incompatible with another
option or wash cycle selected previously, the incompatible
option light will flash 3 times and switches off, while the most
recently selected setting remains lit.
To deselect an option which has been set by mistake, press
the corresponding button again.
Delayed start
It is possible to delay the start time of the wash cycle by 3, 6
or 9 hours.
After selecting the desired wash cycle and any other options,
select Delayed Start by pressing the Delayed Start button re-
peatedly; the washing (3 hours), drying (6 hours) and end (9
hours) indicator lights will flash in succession.
If the Delayed Start button is pressed again, the option is de-
selected.
After the selection process, the countdown will begin if the Start/
Pause button is pressed. The selected delay period indicator
light flashes and the Start/Pause button stops flashing (fixed
light).
When the time has elapsed, the indicator light corresponding
to the selected delay period stops flashing (fixed light) and the
wash cycle begins.
The Delayed Start function cannot be set once the wash
has already started.
Half load
If there are not many dishes to be washed, a half load cycle
may be used in order to save water, electricity and detergent.
Select the wash cycle and press the HALF LOAD button: the
indicator light will illuminate.
Remember to halve the amount of detergent.
It is better to use powder detergent in this case.
*
Only available in selected models.
EN
7