Package Contents - ProSwitch Quad Series 3200 Examine the shipping container for obvious damage prior to installing this product. Notify the carrier of any damage that you believe occurred during shipment. Ensure that the items listed below are included. The QS3200 package contains the following: QS3200 switch chassis AC power cord...
100Base-FX Fiber Modules Fiber modules are available in the following configurations: PM-2SC Fiber module with two 100Base-FX multimode ports with SC connectors PM-2ST Fiber module with two 100Base-FX multimode ports with ST connectors PM-2MTRJ Fiber module with two 100Base-FX multimode ports with MTRJ connectors PM-4SC Fiber module with four 100Base-FX multimode ports with SC connectors PM-4ST...
Your switch comes with two rack mounting brackets which can be used to mount the switch on an EIA 19” standard rack. Attach the brackets to the switch using the screws provided. Next, install the switch in the rack using the screws provided to attach the brackets to the rack.
Set the power switch to ON and verify that the Power LED is lit. If it is not, check the following: The power switch is in the ON position. The power cord is properly connected to the wall outlet and to the power connection on the switch. The wall outlet is functional.
Connecting the 100Base-FX Modules Remove the protective plastic covers from the fiber connectors on the module. Plug the ST (or SC) connector on the fiber cable into the fiber socket on the module. Connect the other end of the fiber optic segment to an appropriate device fitted with a 100Mbps adapter. Check the LED indicators on the front of the switch to ensure that the module is operating correctly.
Red Full Duplex/Col indicators are illuminated when that port is in full duplex mode. The indicator is off when that port is in half duplex mode. Full Duplex/Col When a collision occurs on the network connected to a port, that Full Duplex/Col indicator blinks.
Page 11
100Base-FX Fiber Modules (2 and 4-port modules) The fiber connectors (ST, SC or MTRJ) provide the link to multimode fiber cabling in either the two or four port modules. You can use the dip switch settings described in Table 2 to set the operating mode to half or full duplex. DIP Sw itch Location Port 1 Port 2...
1000Base Modules On the 1000Base modules, if the dip switch is set to OFF, N-Way is enabled. Full and half duplex cannot be enabled if auto-negotiation is in use. If auto-negotiation is disabled, the DIP switch for half and full duplex is enabled.
All returns for repair must be accompanied by a Return Material Authorization (RMA) number. To obtain an RMA number, call Waters Network Systems Customer Service at 800.328.2275 during business hours in 8:00 am to 5:00 pm (CT) email netinfo@wtrs.com. When calling, please have the following information readily available:...
Shipping and Packaging Information Should you need to ship the unit back to Waters Network Systems, please follow these instructions: Package the unit carefully. It is recommended that you use the original container if available. Units should be wrapped in a "bubble-wrap"...